Úvod » Prístroje NHC » Rozvádzačové prvky » Controller » NHC Riadiaci modul
NHC Riadiaci modul
Kompletné špecifikácie
To je centrálna riadiaca jednotka systému. Každá inštalácia musí mať jeden riadiaci modul pre naprogramovanie systému. Funkčnosť a stav modulov skontrolujete jedným stlačením testovacieho tlačidla. Programovacím tlačidlom naprogramujete základné funkcie ako osvetlenie a ovládanie roliet a žalúzií bez toho, aby ste potrebovali počítač. Všetky nastavenia sa uložia v tomto module. Riadiaci modul sa dodáva s návodom na inštalovanie a použitie.
Špecifikácia
Riadiaci modul pre Niko Home Control. The controller operates the Niko Home Control installation based on the pre-programmed settings stored in the system (internal memory chip).
One controller is required per installation. A second controller may be used to operate as a back-up.
Only the POWER LED of the power supply module and the ETHERNET LED of the IP module will be lit when the Niko Home Control installation is functioning properly. The remaining LEDs are not lit, to help save energy.
When the module is functioning properly, the STATUS LED will light up in TEST mode only. If one or several errors occur, the LED will blink to indicate the error code of the error with the highest priority.
A number of basic functions can be temporarily programmed manually. This allows you to test the lighting options or operate the roll-down shutters during the construction of your dwelling. Product in accordance with over-voltage category III and pollution degree II.
- Sliding contact to connect the module to the following module on the DIN rail
- One RJ45-port for programming using the PC via TCP/IP
- Button for manual programming
- Minimálna prevádzková teplota: 0 °C
- Maximálna prevádzková teplota: +45 °C
- Rozmery DIN lišty: DIN 2TE
- Romery: 225 x 145 x 60 mm
- Označenie: CE