Úvod » Prístroje NHC » Rozvádzačové prvky » Energie » NHC Počítadlo impulzov
Tento modul v kombinácii s eko displejom meria spotrebu plynu, vody a elektriny. Výsledné merania sa zobrazia na displeji. Pomocou eko displeja alebo softvéru na sledovanie energie môžete sledovať spotrebu a produkciu elektrickej energie a zistiť odchýlky. Aby ste získali podrobnú analýzu a históriu musí byť systém vybavený IP modulom, ktorý sa zaznamenáva a ukladá všetky namerané údaje. Modul môžete pripojiť na tri rôzne počítadlá a tento modul má na každý kanál jednu LED na získanie spätnej a jednu stavovú LED.
Počítadla impulzov pre Niko Home Control. The pulse counter allows you to monitor gas, water and electricity consumption as well as electricity production.
This module has three pulse inputs. It can therefore connected to up to three metres. The pulse counter counts the pulses and converts the sum into m³ or kWh. The scale factor of the pulses (e.g. 1 pulse = 10 litres) and the meter type (gas, water or electricity) can be selected via the programming software. The eco-display shows the total electricity consumption and the electricity production, if applicable. If you want to keep track of your home’s past electricity consumption, then the installation must be fitted with an IP module that logs the measuring data. A detailed overview of these data can be requested via the touchscreen, a smartphone or the Niko Home Control energy software.
If the Niko Home Control installation is fitted with an IP module, then this module can be used to store measuring data. How long the IP module will store this data for will depend on the number of channels in the installation. An overview is provided in the table below. If the resident wishes to store this data for an extended period of time, then he or she must back up this data using the Niko Home Control energy software before the existing data will be overwritten.
Use the programming software to select the currency of your choice: EUR or GBP. Gas and water consumption are expressed in m³, and electricity in kWh. The following settings can be selected per channel:
When the module is functioning properly, the STATUS LED will light up in TEST mode only. If one or several errors occur, the LED will blink to indicate the error code of the error with the highest priority.