Úvod » Prístroje NHC » Rozvádzačové prvky » Ovládanie osvetlenia » NHC Modul analógových výstupov 1-10V
NHC Modul analógových výstupov 1-10V
Kompletné špecifikácie
Pomocou analógového riadiaceho modulu 1-10 V je možné pripojiť k inštalácii Niko Home Control až tri stmievače a/alebo spínacie zariadenia:
- stmievače s analógovým vstupom 1-10 V pre stmievanie monochromatických LED
- elektronický predradník pre žiarivkové osvetlenie
- vysoko výkonné stmievače s analógovým vstupom 1-10 V.
Špecifikácia
Analógový riadiaci modul 1 - 10 V pre Niko Home Control. Up to three dimmers and/or switching devices can be connected to the Niko Home Control installation using the analogue control module 1-10 V:
- dimmers with an analogue input of 1-10 V for dimming monochrome LEDs.
- electronic control gear for fluorescent lights.
- high-power dimmers with an analogue input of 1-10 V.
Useful Niko reference codes: 05-715, 65-410, 65-412, 65-416, 330-00701.
The output will send a signal between 1 and 10 V to control the connected dimmer/electronic control gear, which allows programmed actions or mood settings to be activated. By pressing the corresponding button, the status of each output can be changed manually and temporarily to connect a light. Please remember that the activation or deactivation is only temporary as it will be overruled by the next bus communication.
The distance between the dimmers and the module should not exceed 50m. A maximum of three dimmers can be connected per module.
When the module is functioning properly, the STATUS LED will light up in TEST mode only. If one or several errors occur, the LED will blink to indicate the error code of the error with the highest priority.
- 3 outputs: 1-10 V (FELV, functional extra-low voltage), current-controlled (I)
- option of connecting 3 individual phases
- maximum distance between dimmers and module: 50 m
- maximum load: 20 mA per channel, protected from 50 mA per channel and maximum 11 V
- galvanic isolation when connecting the power circuit (6 A per channel)
- Sliding contact to connect the module to the following module on the DIN rail
- Pripojovacie svorky: 2 x 6 screw terminals
- Prierez vodičov: 3 x 1.5 mm² or 2 x 2.5 mm² or 1 x 4 mm² per connection terminal
- Minimálna prevádzková teplota: 0 °C
- Maximálna prevádzková teplota: +45 °C
- Rozmery DIN lišty: DIN 4TE
- Romery: 89 x 71 x 66 mm
- Označenie: CE